Networx nx 1300 e user manual

Table of Contents. Previous Page. Next Page. Authority Level The level of access an individual has when using an alarm panel. Central Station The location where alarm data is sent during an alarm report. User Code A four 4 or six 6 digit entry code used to arm or disarm the system. The instant light can be toggled on or off by pressing the [Stay] key while the system is armed. Your system may not be programmed for these activation keys see page 1.

You should press these keys only in an emergency situation that requires response by emergency personnel. If your system is programmed for these functions, the following reports can be sent. The armed and exit lights will illuminate. You may now leave the building. NOTE: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that the exit time is about to expire. Step 2 Enter user code, if required optional.

The bypass light flashes. Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass, i. The instant light can be toggled on or off by pressing the [Stay] key while the system is armed. Your system may not be programmed for these activation keys see page 1. You should press these keys only in an emergency situation that requires response by emergency personnel. If your system is programmed for these functions, the following reports can be sent.

NOTE: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that the exit time is about to expire. Step 2 Enter user code, if required optional. The bypass light flashes. Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass, i.

NOTE: For partitioned systems, someone changing the code of another person must have access to all or more partitions than the user being changed. Step 2 The ready light will flash. Your system must be Disarmed to use the Reset function.

Step 1 Press [r]-[7]. Resets have now been performed. Step 2 If the keypad begins beeping, the reset did not execute properly. Enter your code to silence the keypad. As mentioned earlier, certain security status message simply indicate an old status stored in memory.

At this point, your keypad should stay silent and your alarm memory should reset. If the keypad beeps immediately after attempting these steps, it means that the reset did not properly execute. In this case, try the same steps a few minutes later. If several attempts at a reset fail, call your security provider to straighten the issue out. The NX-8 panel has a separate light dedicated solely to communicating status updates regarding smoke detectors connected to the alarm. This exact scenario happens every time a fire device sounds.

Most fire trouble messages, in fact, can be cleared with a reset. As long as you replace the cover, a memory reset should resolve this issue. This means that the panel has stopped recognizing one of the fire detection devices in the field.

If resetting the panel does not clear this issue, you will likely need a technician to troubleshoot. The NX-8 has many more potential trouble statuses than the Concord 4 panel, so we will not list every possible message. However, we will detail some of the most prominent statuses that indicate the need to take action. Of course, if your power is out then you already know the cause of the issue. If there is nothing you can do to improve this connection, you are likely experiencing a phone issue in your area.

Check your other household phones to verify this. In either case, silencing the alarm with your code will allow you to live in peace until the larger issue at fault is resolved. In some cases, a trouble signal generated by your alarm requires a service call from a technician to solve. Listshack CC BY 2.